Rainbow Electronics GM862-QUAD-PY - Manual (Page 187)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 187 of 434
+CNMI - New Message Indications To Terminal Equipment SELINT 0 / 1
- CBM Content of Message
- SMS-STATUS-REPORTs reporting option
0 - status report receiving is not reported to the DTE
1 - the status report is sent to the DTE with the following unsolicited result
code:
(PDU Mode)
+CDS:
where:
- PDU length
- message PDU
(TEXT Mode)
+CDS: ,,,,,
2 - if a status report is stored, then the following unsolicited result code is
sent:
+CDSI: ,
where:
- memory storage where the new message is stored
"SM"
- location on the memory where SM is stored
- buffered result codes handling method:
0 - TA buffer of unsolicited result codes defined within this command is
flushed to the TE when =1..3 is entered (OK response shall be
given before flushing the codes)
1 - TA buffer of unsolicited result codes defined within this command is
cleared when =1..3 is entered.
Note: issuing AT+CNMI is the same as issuing the Read command.
Note: issuing AT+CNMI= is the same as issuing the command
AT+CNMI=0.
AT+CNMI? Read command returns the current parameter settings for +CNMI command
in the form:
+CNMI: ,,,,
AT+CNMI=? Test command reports the supported range of values for the +CNMI
command parameters.