Rainbow Electronics GM862-QUAD-PY - Manual (Page 53)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 53 of 434
D – Dial SELINT 2
Note: the numbers accepted are 0-9 and *,#,”A”, ”B”, ”C”, ”D”,”+”.
Note: for backwards compatibility with landline modems modifiers “T”, ”P”,
”R”, ”,”, ”W”, “!”, “@” are accepted but have no effect.
ATD>[;] Issues a call to phone number which corresponding alphanumeric field is
; all available memories will be searched for the correct entry.
If “;” is present a voice call is performed.
Parameter:
- alphanumeric field corresponding to phone number; it must be
enclosed in quotation marks.
Note: parameter is case sensitive.
Note: used character set should be the one selected with +CSCS.
ATD>>[;] Issues a call to phone number in phonebook memory storage >,
entry location (available memories may be queried with
AT+CPBS=?).
If “;” is present a voice call is performed.
Parameters:
- phonebook memory storage; it must not be enclosed in quotation
marks.
SM - SIM phonebook
FD - SIM fixed dialling-phonebook
LD - SIM last-dialling-phonebook
MC - device missed (unanswered received) calls list
RC - ME received calls list
MB - mailbox numbers stored on SIM, if this service is provided by the
SIM (see #MBN).
- entry location; it should be in the range of locations available in the
memory used.
ATD><n>[;] Issues a call to phone number in entry location of the active
phonebook memory storage (see +CPBS).
If “;” is present a voice call is performed.
Parameter:
- active phonebook memory storage entry location; it should be in the
range of locations available in the active phonebook memory storage.
ATDL Issues a call to the last number dialed.
ATDS=[;] Issues a call to the number stored in the MODULE internal phonebook
position number .
If “;” is present a voice call is performed.
Parameter:
- internal phonebook position to be called (See commands &N and