Rainbow Electronics GM862-QUAD-PY - Manual (Page 204)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 204 of 434
@CMGL - List Messages Improved SELINT 0
Note If Text Mode (+CMGF=1) the Test command output is not included in
parenthesis
AT@CMGL=?
@CMGL: "REC UNREAD","REC READ","STO UNSENT",
"STO SENT","ALL"
Reference GSM 07.05
@CMGL - List Messages Improved
SELINT 1
AT@CMGL
[=] Execution command reports the list of all the messages with status value
stored into message storage ( is the message
storage for read and delete SMs as last settings of command +CPMS).
The parameter type and the command output depend on the last settings of
command +CMGF (message format to be used)
(PDU Mode)
Parameter:
0 - new message
1 - read message
2 - stored message not yet sent
3 - stored message already sent
4 - all messages.
Each message to be listed is represented in the format:
@CMGL: ,,
where
- message position in the memory storage list.
- status of the message
- length of the PDU in bytes
- message in PDU format according to GSM 3.40
(Text Mode)
Parameter:
"REC UNREAD" - new message
"REC READ" - read message
"STO UNSENT" - stored message not yet sent
"STO SENT" - stored message already sent
"ALL" - all messages.
Each message to be listed is represented in the format:
@CMGL: ,,[,,,,]