Rainbow Electronics GM862-QUAD-PY - Manual (Page 109)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 109 of 434
+CSSN - SS Notification SELINT 0 / 1
Note: issuing AT+CSSN is the same as issuing the Read command.
Note: issuing AT+CSSN= is the same as issuing the command
AT+CSSN=0.
AT+CSSN? Read command reports the current value of the parameters.
AT+CSSN=? Test command reports the supported range of values for parameters ,
.
Reference GSM 07.07
+CSSN - SS Notification
SELINT 2
AT+CSSN=[
[,]] It refers to supplementary service related network initiated notifications.
Set command enables/disables the presentation of notification result codes
from TA to TE.
Parameters:
- sets the +CSSI result code presentation status
0 - disable
1 - enable
- sets the +CSSU result code presentation status
0 - disable
1 - enable
When =1 and a supplementary service notification is received after a
mobile originated call setup, an unsolicited code:
+CSSI:
is sent to TE before any other MO call setup result codes, where:
:
1 - some of the conditional call forwardings are active
2 - call has been forwarded
3 - call is waiting
5 - outgoing calls are barred
6 - incoming calls are barred
When =1 and a supplementary service notification is received during a
mobile terminated call setup or during a call, an unsolicited result code:
+CSSU:
is sent to TE, where:
:
0 - this is a forwarded call (MT call setup)
2 - call has been put on hold (during a voice call)
3 - call has been retrieved (during a voice call).
AT+CSSN? Read command reports the current value of the parameters.
AT+CSSN=? Test command reports the supported range of values for parameters ,