Rainbow Electronics GM862-QUAD-PY User Manual
Page 117
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 117 of 434
+CPIN - Enter PIN
SELINT 0 / 1
%E #SKTSET
+CGMI
$GPSP
%L #SKTOP
+CGMM
$GPSPS
%Q #SKTCT
+CGMR
$GPSR
\Q #SKTSAV
+GMI
$GPSD
\R #SKTRST
+GMM
$GPSSW
\V #ESMTP
+GMR
$GPSAT
#SELINT #EADDR +CGSN
$GPSAV
#CGMI #EUSER +GSN
$GPSAI
#CGMM #EPASSW +CHUP
$GPSAP
#CGMR #SEMAIL +CRLP
$GPSS
#CGSN #EMAILD +CR
$GPSNMUN
#CAP #ESAV +CRC
$GPSACP
#SRS #ERST +CSNS
$GPSWK
#SRP #EMAILMSG
+CREG
$GPSSAV
#STM #CSURV
+COPS
$GPSRST
#PCT #CSURVC
+CLIP
$GPSCON
#SHDN #CSURVU
+CPAS
$GPSPRG
#WAKE #CSURVUC
+CFUN
#QTEMP
All the above commands, but the ones in the grayed cells, can be issued
even if the SIM card is not inserted yet.
All the above commands, but +CSDH and +CNMI, can be issued even if ME
is waiting for phone-To-SIM card password to be given
Reference GSM
07.07
+CPIN - Enter PIN
SELINT 2
AT+CPIN=
[,
Set command sends to the device a password which is necessary before it
can be operated (SIM PIN, SIM PUK, PH-SIM PIN, etc.).
If the PIN required is SIM PUK or SIM PUK2, the
This second pin,
The command may be used to change the SIM PIN by sending it with both
parameters
request is pending the command will return an error code and to change the
PIN the command +CPWD must be used instead.
Parameters:
To check the status of the PIN request use the command AT+CPIN?
Note: If all parameters are omitted then the behaviour of Set command is
the same as Read command.