Rainbow Electronics GM862-QUAD-PY - Manual (Page 377)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 377 of 434
#CSURV - Network Survey SELINT 0 / 1
2
3
> - routing area code
0..255 -
> - SPLIT_PG_CYCLE support
..0 - SPLIT_PG_CYCLE is not supported on CCCH on this cell
..1 - SPLIT_PG_CYCLE is supported on CCCH on this cell
- priority access threshold
0 -
3..6 -
- network control order
0..2 -
- timer 3168
- timer 3192
- discontinuous reception max time (in seconds)
- packed control ack
- blocked sequenc countdown max value
- alpha parameter for power control
- type of channel which shall be used for downlink
measurements for power control
0 - BCCH
1 - PDCH
(For non BCCH-Carrier)
arfcn: rxLev:
where:
- RF channel
- receiption level (in dBm)
Lastly, the #CSURV output ends in two ways, depending on the last
#CSURVF setting:
if #CSURVF=0 or #CSURVF=1
The output ends with the string:
Network survey ended
if #CSURVF=2
the output ends with the string:
Network survey ended (Carrier: BCCh: )
where
> - number of scanned frequencies
> - number of found BCCh