Rainbow Electronics GM862-QUAD-PY User Manual

Page 264

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 264 of 434

#ADC - Analog/Digital Converter Input

SELINT 0 / 1

2 - available only for GE863-QUAD, GE863-PY, GE864-QUAD, GE864-
PY, GC864-QUAD and GC864-PY
3 - available only for GE863-QUAD, GE863-PY, GE864-QUAD, GE864-
PY, GC864-QUAD and GC864-PY

- required action
2 - query ADC value

- direction; its interpretation is currently not implemented
0 - no effect.

If all parameters are omitted the command reports all pins voltage,
converted by ADC, in the format:

#ADC: [#ADC: […]]

Note: The command returns the last valid measure.

AT#ADC?

Read command has the same effect as Execution command when all
parameters are omitted.

AT#ADC=?

Test command reports the supported range of values of the command
parameters , and

#ADC - Read Analog/Digital Converter input

SELINT 2

AT#ADC=
[,
[,

]]

Execution command reads pin voltage, converted by ADC, and
outputs it in the format:

#ADC:

where:
- pin voltage, expressed in mV

Parameters:
- index of pin
1 - available for GM862-QUAD, GM862-QUAD-PY, GM862-GPS, GE863-

QUAD, GE863-PY, GE863-GPS, GE864-QUAD, GE864-PY, GC864-
QUAD and GC864-PY

2 - available only for GE863-QUAD, GE863-PY, GE864-QUAD, GE864-

PY, GC864-QUAD and GC864-PY

3 - available only for GE863-QUAD, GE863-PY, GE864-QUAD, GE864-

PY, GC864-QUAD and GC864-PY

- required action
2 - query ADC value

- direction; its interpretation is currently not implemented
0 - no effect.

Note: The command returns the last valid measure.

AT#ADC?

Read command reports all pins voltage, converted by ADC, in the format: