Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1849 - Manual (Page 64)

9. 30"-36" Head Platform Left Hand Drive
64 PNEG-1849 30"-36" Bucket Elevator Platform and Ladder “X” Series
For 36" Left Side Drive
Orient the Channel
1. At Discharge End orient the channel so that:
a. Channel opening is outward, toward the discharge end of the head.
b. Holes labeled with “Y” face up.
c. Hole Y1 is on the non-drive side of the lower head.
d. Hole Y7 is on the drive side of the lower head.
e. Cross deck support channel extends farther on the drive side than on hatch side of lower head.
2. At Up-Leg End orient the channel so that:
a. Channel opening outward, toward the up-leg end of the head.
b. Holes labeled with “X” face up.
c. Hole X1 is on the non-drive side of the lower head.
d. Hole X7 is on the drive side of the lower head.
e. Cross deck support channel extends farther on the drive side than on hatch side of lower head.
(See Figure 9D on Page 65.)
3. Attach cross deck support channels (HP36DSCX) to the top most set of holes of the lower head
brackets (HSP36130) using 3/8" x 1" bolts and nuts. (See Figure 9E on Page 65.)
*NOTE: The channels MUST be oriented as shown in Figure 9D and Figure 9E on Page 65 in order for
the decking and subsequent assembly to be done correctly.