Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1849 - Manual (Page 46)

8. 30"-36" Head Platform Right Hand Drive
46 PNEG-1849 30"-36" Bucket Elevator Platform and Ladder “X” Series
Attach Main Support Channels to Lower Head
For 30" Right Side Drive
Orient the Channel
Place lower head section on solid and level surface.
1. At Discharge End orient the channel so that:
a. Channel opening is inward, toward the bracket.
b. Hole labeled with “Y” face up.
c. Holes Y1 is on the non-drive/hatch side of the lower head.
d. Hole Y7 is on the drive side of the lower head.
e. Cross deck support channel extends farther on the drive side than on hatch side of lower head.
2. At Up-Leg End orient the channel so that:
a. Channel opening outward, toward the up-leg end of the head.
b. Holes labeled with “Y” face up.
c. Hole Y1 is on the non-drive side of the lower head.
d. Hole Y7 is on the drive side of the lower head.
e. Cross deck support channel extends farther on the drive side than on hatch side of lower head.
(See Figure 8C on Page 47.)
3. Attach cross deck support channels (HP36DSCX) to the top-most set of holes of the lower head
brackets (HSP36130) using 3/8" x 1" bolts and nuts and properly. (See Figure 8C on Page 47.)
*NOTE: The channels MUST be oriented as shown in Figure 8B and Figure 8C on Page 47 in order for
the decking and subsequent assembly to be done correctly.