Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1849 - Manual (Page 62)

9. 30"-36" Head Platform Left Hand Drive
62 PNEG-1849 30"-36" Bucket Elevator Platform and Ladder “X” Series
For 30" Left Side Drive
Orient the Channel
1. At Discharge End orient the channel so that:
a. Channel opening is outward, toward the discharge end of the head.
b. Holes labeled with “X” face up.
c. Hole X1 is on the non-drive side of the lower head.
d. Hole X7 is on the drive side of the lower head.
e. Cross deck support channel extends farther on the drive side than on hatch side of lower head.
2. At Up-Leg End orient the channel so that:
a. Channel opening outward, toward the up-leg end of the head.
b. Holes labeled with “X” face up.
c. Hole X1 is on the non-drive side of the lower head.
d. Hole X7 is on the drive side of the lower head.
e. Cross deck support channel extends farther on the drive side than on hatch side of lower head.
(See Figure 9B on Page 63.)
3. Attach cross deck support channels (HP36DSCX) to the top-most set of holes of the lower head
brackets (HSP36130) using 3/8" x 1" bolts and nuts. (See Figure 9C on Page 63.)
*NOTE: The channels MUST be oriented as shown in Figure 9B and Figure 9C on Page 63 in order for
the decking and subsequent assembly to be done correctly.