Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1849 - Manual (Page 48)

8. 30"-36" Head Platform Right Hand Drive
48 PNEG-1849 30"-36" Bucket Elevator Platform and Ladder “X” Series
For 36" Right Side Drive
Orient the Channel
Place lower head section on solid and level surface.
1. At the Discharge End orient the channel so that:
a. Channel opening is outward, toward the discharge end of the head.
b. Holes labeled with “X” face up.
c. Hole X1 is on the non-drive side of the lower head.
d. Hole X7 is on the drive side of the lower head.
e. Cross deck support channel extends farther on the drive side than on hatch side of lower head.
2. At the Up-Leg End orient the channel so that:
a. Channel opening outward, toward the up-leg end of the head.
b. Holes labeled with “Y” face up.
c. Hole Y1 is on the non-drive side of the lower head.
d. Hole Y7 is on the drive side of the lower head.
e. Cross deck support channel extends farther on the drive side than on hatch side of lower head.
(See Figure 8D on Page 49.)
3. Attach cross deck support channels (HP36DSCX) to the top-most set of holes of the lower head
brackets (HSP36130) using 3/8" x 1" bolts and nuts and torque properly. (See Figure 8E on Page 49.)
*NOTE: The channels MUST be oriented as shown in Figure 8D and Figure 8E on Page 49 in order for
the decking and subsequent assembly to be done correctly.