Toshiba e-STUDIO 170F - Manual (Page 97)

95
This procedure will discuss Di-
rect Transmission when se-
lected as the default setting or
when Residual Memory has
been depleted.
Load the document face down
in the Document Support (see
page 82).
Adjust the resolution and con-
trast if desired (see pages 83
and 84).
Dial the facsimile number of
the remote party using any of
the four dialing methods.
• One Touch Key Dialing
... See page 89
• Abbreviated Dialing
... See page 90
• Alphabet Dialing
... See page 91
• Keypad Dialing
... See page 92
• Press
STOP
if a dialing er-
ror occurs.
Example of screen displayed
while a number is entered us-
ing Keypad Dialing:
Once the facsimile number is
entered, the dialing starts.
Direct Transmission is used if
there is not enough residual
memory or when a large num-
ber of document pages are to
be sent, etc.
This mode is also useful if the
operator wishes to visually
confirm the actual transmission
of the document to the remote
party.
The documents will remain in
the ADF and be transmitted
one by one.
All transmissions will be sent
via Direct Transmission if the
Memory Transmission function
is set default off (See page
142).
Direct Transmission
Load the Document 1 Dial the Facsimile
Number 2 Start Dialing 3
Direct Transmission as a Default Setting
Line Connection to
the Remote Party 4
Once connected to the desti-
nation facsimile, the screen
below is displayed.
Example of screen displayed
when Residual Memory has
been depleted:
If the destination facsimile is
busy, the screen below is dis-
played.
If the redial procedure is com-
pleted without a success, the
screen below is displayed and
printed the Transmission Re-
port.
After printing
JAN-31 09:43 AM 100%
AUTO RECEIVE
JAN-31 09:43 AM 0%
AUTO RECEIVE
TEL NUMBER =(MAX128)
0559761234
DIALING
0559761234
WAITING TO REDIAL
AUTO RECEIVE
JAN-31 09:43 AM 100%
PRINTING LIST
JAN-31 09:43 AM 100%
LINE BUSY
COMMUNICATING
+81 559 761234