Toshiba e-STUDIO 170F - Manual (Page 83)

81
The following table shows the specifications for original documents that can be
used with this facsimile. Caution:
If the documents are any of the following, they should be copied to plain paper
before transmitting.
• Torn, wrinkled, or damp pages
• Folded pages or pages with holes
• Transparent pages or pages with a smooth, shiny finish
• Cloth or metal sheets
When using originals with the following specifications, use a carrier sheet to
avoid document jams or misfeeds. When using carrier sheets, only one sheet
can be sent at a time.
• Smaller than minimum size.
• With thickness less than 0.05 mm.
To use a carrier sheet, lift the clear cover, place a single document sheet face-
up on the paper sheet. Purchase carrier sheets from your TOSHIBA facsimile
dealer or use a transparency with a paper backing attached at the lead edge.
Document Specifications
NOTES:
• Operator assistance may be required for pages longer than 356 mm (14.02
inches).
• For multiple sheets, the documents must be the same size and paper type.
• A small border region of each document is not imaged when each document
is scanned. The effective scanning area is as shown in the figure below.
Max.
Single Sheet Multiple Sheets
Document
Size
0.06 to 0.15 mm
[0.003 to 0.006 in.]
0.065 to 0.1 mm
[0.003 to 0.004 in.]
Thickness of
Document
Uncoated on both sides Type of Paper
Min.
216 mm (W) x 1000 mm (L)
[8.5 in. (W) x 39.37 in. (L)]
148 mm (W) x 100 mm (L)
[5.83 in. (W) x 3.94 in. (L)]
Effective Scanning
Width
214 mm
[8.43 in.]
Max. Capacity of
Document Tray
Up to 15 sheets (Legal Size)
Up to 40 sheets (A4/Letter Size)
- TRANSMIT CONFIGURATION
A4/Letter/Legal Size
Effective
Scanning
Area
216mm (8.5 inches)
214mm (8.43 inches)
2.5mm (0.1 inches)
2.5mm (0.1 inches)