Toshiba e-STUDIO 170F - Manual (Page 18)

16
The unit should be installed:
• On a horizontal surface.
• Away from direct sunlight, dust, extreme heat and humidity, and vibration.
• Away from sources of strong electrical or magnetic fields, such as televisions or
radios.
• Within reach of an electrical outlet. Use an outlet not shared with equipment that
generates electrical noise or consumes large amounts of electricity, such as an
air conditioner, or a copier.
• Within reach of a telephone connection. Use a dedicated, single-line telephone
connection.
• Allow for adequate ventilation. The rear and sides of the unit need to be clear to
allow proper air flow to the unit’s power supply.
WARNING • After a suitable place has been selected for the installation of
the e-STUDIO, please do not change it. Avoid excessive
heat, dust, vibration and direct sunlight. Also, provide proper
ventilation as the copier emits a small amount of ozone.
• The socket outlet should be installed near the equipment and
be easily accessible. Pull out the plug from the outlet more
than once a year to clean around the prongs. Accumulating
dust and dirt could cause a fire due to the heat released by
electric leakage.
NOTE:
Be sure to hold the e-STUDIO170F by 2 place
with both hands as shown in the illustration on
the right.
Select a Desirable Location
3