Toshiba e-STUDIO 170F - Manual (Page 33)

31
Drum Unit Replacement
Replacement Drum Kits for
your TOSHIBA facsimile in-
clude a Drum Unit.
Your TOSHIBA facsimile has
been designed to display a two-
stage alert to replace the Drum
Unit once it has been depleted.
The first stage is a “DRUM
UNIT WARNING” that alerts
you that the Drum Unit is near
its end of life and should be re-
placed at your earliest con-
vince. The unit will continue to
receive and print facsimile
messages during this stage.
The second stage is the “RE-
PLACE DRUM UNIT” notice.
When this message is dis-
played, the machine can no
longer print documents. Recep-
tions will be stored in memory
until the Drum Unit has been
replaced.
For the purpose of determining
Drum usage;
Each legal-size sheet of paper
counts as 1.3 letter-size sheets
of paper.
Lift up and holding the green
handle, gently pull out the Pro-
cess Unit.
CAUTION:
Always hold the Process
Unit by the green handle.
STORAGE NOTES:
The Drum Unit is a very im-
portant part of this facsimile.
Handle it with care as shown
below.
Keep the Drum Unit within a
temperature range of 0-35°C
(32-95°F) and a humidity
range of 20-80%RH (without
condensation).
Do not store or use the Drum
Unit in an environment where
the temperature changes ex-
cessively.
Do not touch the light sensi-
tive drum because its sur-
face will be easily damaged.
Do not place the light sensi-
tive drum in a location where
it is exposed to direct sun-
light or high intensity light
(more than 200 lx) such as
near a window.
Hold the Front Cover by the
grips on both sides of its upper
part and pull it down to open it.
NOTE:
Do not pull the Front Cover
too strongly when opening
it.
Open the Front
Cover 1 Remove the Process
Unit 2
Detach the Toner
Cartridge from the
Drum Unit
3
Move the lever of the Toner
Cartridge in the direction of the
arrow to detach it from the
Drum Unit.
NOTES:
•
Keep the Toner Cartridge
level with the Drum Unit
when they are detached.
• Do not touch the PC Drum
under the lid of the Drum
Unit. The image quality
could be degraded.
• Do not touch the metal area
of the Toner Cartridge. It
could be damaged due to
electrostatic interference.