Toshiba e-STUDIO 170F - Manual (Page 164)

162
This function prevents your
facsimile from sending to an
incorrectly dialed phone. With
this function set ON, the dialed
number will be checked against
the remote facsimile’s pro-
grammed Transmit Terminal ID
(TTI). The transmission will
only occur if the number dialed
matches the remote party’s
number.
You can turn the SECURITY
TX ON for a single transmis-
sion using this procedure.
NOTES:
• To change the default set-
ting of this function, refer
to page 143. The status
selection in this operation
will take precedence over
the default setting.
• The facsimile will auto-
matically return to its de-
fault status immediately
after that transmission is
complete.
Press:
+
+
+
+
Turn ON Security Transmis-
sion by pressing: Load the document face down
in the Document Support (see
page 83).
Adjust the resolution and con-
trast if desired (see pages 84
and 85).
Enter the number of the remote
facsimile using any of the fol-
lowing dialing methods or you
may designate another option
at this point.
• One Touch Key Dialing
... See page 89
• Abbreviated Dialing
... See page 90
• Alphabet Dialing
... See page 91
• Keypad Dialing
... See page 92
Security Transmission
Load the Document 1 Display the
SECURITY TX Menu 2 Select the Option 3 Enter the Facsimile
Number 4
- TRANSMISSION OPTIONS
JAN-31 09:43 AM 100%
AUTO RECEIVE
1.ON
SECURITY TX
2.OFF
JAN-31 09:43 AM 100%
ENTER TEL NUMBER
MENU
The following screen is dis-
played. You may dial the re-
mote facsimile for your com-
munication job. The display will
return to the Standby Mode in
about 60 seconds if no keys
are pressed.
Turn OFF Security Transmis-
sion by pressing: