Toshiba e-STUDIO 170F - Manual (Page 222)

220
ADF TEST
Press:
+
+
+
+
Select the ADF TEST
Menu 1
The ADF test checks the op-
eration of the ADF by trans-
porting and unloading docu-
ments. You can check that the
ADF is normal if the number of
documents loaded is consis-
tent with the number of docu-
ments transported and un-
loaded.
Load the documents in the
document support. If a document jam occurs dur-
ing transport, the screen below
is displayed.
Remove the jammed docu-
ments, the screen below is dis-
played.
ADF TEST
LOAD DOCUMENT
ADF TEST
PAGES 01
ADF TEST
DOCUMENT JAM
To continue the ADF Test,
press:
ADF TEST
[STOP] TO COMPLETE
Load the Documents 2
ADF TEST
PRESS[START]
To end the test, press:
Select the ADF Test
Result 3
If the number of documents
loaded is consistent with the
number of documents unload,
press:
You can change the transport
speed by pressing
MODE
.
STD: Fast
FINE (Same when HALF
TONE is set): Medium
U-FINE (Same when HALF
TONE is set): Slow
MENU
Press:
The documents will be trans-
ported one by one and the
number of documents unloaded
will be displayed at the lower
right on the screen.
START
Go to Step 3.
STOP
Return to Step 2.
START
If a document has not fed prop-
erly (even once), press:
2.NG
ADF TEST
1.OK