FUJITSU SPARC M4000 - Manual (Page 67)

Chapter 2 Setting Up XSCF 2-11
20. Configure the Altitude Administration settings.
• Make the Altitude Administration. showaltitude (8), setaltitude(8)
(See Section 2.2.15, “Altitude
Administration” on page 2-127 )
Note – Normally, the Altitude Administration is set up by FE. Also, the privilege of
fieldeng is required.
21. Configure the DVD drive/tape drive unit settings.
• Display DVD drive/tape drive unit
information, including connection
information, and configure the devices.
cfgdevice (8)
(See Section 2.2.16, “DVD Drive/Tape Drive
Unit Administration” on page 2-128 )
22. Configure the capacity on demand (COD) settings.
• Display and set the COD. showcodlicense (8), addcodlicense(8),
deletecodlicense (8), showcod(8),
setcod (8), showcodusage(8)
(See Section 2.2.17, “COD Administration”
on page 2-131 )
2.1.2 Setup Summary Using the XSCF Web
This section describes the setup summary using the XSCF Web. This procedure
contains examples of the windows that are used. For details on settings, see the
corresponding parts of
Section 2.2, “Specifying the XSCF Settings” on page 2-14 .
Before attempting to establish a connection to the XSCF and log in from the web
browser window of the XSCF Web, perform
Step 1 - Step 8 in Section 2.1.1, “Setup
Summary by the XSCF Shell” on page 2-2 , and enable https in Section 2.2.6, “Https
Administration” on page 2-54 . If you have already performed Step 1 to Step 8 in
Section 2.1.1, “Setup Summary by the XSCF Shell” on page 2-2 , start the procedure
in this section at Step 9 .
In addition, establish one-to-one communication between the PC and the XSCF
during initial setup.