FUJITSU SPARC M4000 User Manual
Page 165
Chapter 2 Setting Up XSCF 2-109
2. Use the showboards (8) command to display XSB status information.
XSCF> showboards –va
XSB R DID(LSB) Assignment Pwr Conn Conf Test Fault COD
---- - -------- ----------- ---- ---- ---- ------- -------- ----
00-0 02(00) Assigned y y y Passed Normal n
01-0 02(07) Assigned y y y Passed Normal n
01-1 02(08) Assigned y y y Passed Normal n
01-2 02(09) Assigned y y y Passed Normal n
01-3 02(10) Assigned y y y Passed Normal n
3. Use the poweroff (8) command to power off domain ID 2.
XSCF> poweroff –d 2
DomainIDs to power off:02
Continue? [y|n] :y
02 :Powering off
*Note*
This command only issues the instruction to power-off.
The result of the instruction can be checked by the
"showlogs power".
4. Use the showboards (8) command to display XSB status information.
XSCF> showboards –va
XSB R DID(LSB) Assignment Pwr Conn Conf Test Fault COD
---- - -------- ----------- ---- ---- ---- ------- -------- ----
00-0 02(00) Assigned n n n Passed Normal n
01-0 02(07) Assigned n n n Passed Normal n
01-1 02(08) Assigned n n n Passed Normal n
01-2 02(09) Assigned n n n Passed Normal n
01-3 02(10) Assigned n n n Passed Normal n
5. Use the deleteboard (8) command to delete an XSB.
XSCF> deleteboard -c unassign 1-1
XSB#01-1 will be unassigned from domain immediately.
Continue?[y|n] :y
XSCF>