FUJITSU SPARC M4000 - Manual (Page 241)

Chapter 5 Overview of the XSCF Shell 5-5
setdomainmode Sets a hardware initial diagnostic level (No, standard, maximum).
Enables or disables break signal sending, host watchdog, and automatic boot.
showdomainmode Displays the hardware initial diagnostic level.
Displays information of enabled or disabled status on break signal sending, Host
watchdog , and automatic boot.
sendbreak Sends a break signal to the server.
showresult Displays the exit status of the most recently executed command.
setlocale Sets locale.
showlocale Displays locale.
setaltitude Sets altitude.
showaltitude Displays altitude.
cfgdevice Sets the connection destination of the DVD drive unit and tape drive unit. Displays
the setting status information.
addcodlicense Applies the license key obtained from the license center to the system.
deletecodlicense Deletes the license key applied to the system.
showcodlicense Displays the license keys applied to the system.
showcodusage Displays license usage information.
setcod Configures COD settings.
showcod Displays COD settings.
console Connects to a domain console.
showconsolepath Displays the operating status of the main console.
showenvironment Displays the temperature, humidity, voltage, and fan rotation speed.
showstatus Lists degraded components.
showhardconf Displays all components mounted in the server.
poweron Turns on power to all domains or the specified domain.
poweroff Turns off power to all domains or the specified domain.
reset Resets the specified domain.
Note: The following three reset modes are available:
por: Domain system reset
request: Domain panic instruction
xir: Domain CPU reset
setpowerupdelay Sets the warm-up time and the air-conditioning wait time.
TABLE 5-1 XSCF Commands (Continued)
Command Description