2 login to xscf user accounts, 1 before logging in, Login to xscf user accounts 5–7 – FUJITSU SPARC M4000 User Manual
Page 243: Before logging in 5–7
Chapter 5 Overview of the XSCF Shell
5-7
5.2
Login to XSCF User Accounts
This section describes how to log in to XSCF. The user can log in to XSCF from an
XSCF-LAN port using either SSH or telnet, or from the serial port.
5.2.1
Before Logging In
Note the following before attempting to log in:
■
For details on how to create, add, and delete user accounts, see
■
After login, if the shell has not been accessed for a certain period, XSCF
automatically terminates the shell. The default timeout period is 10 minutes. The
timeout period can be specified. For details on specifying the timeout period, see
.
■
In one domain, only one user can use the RW console (write-enabled console).
While one user is using the RW console, another user cannot start another RW
console in the same domain. For details on console connection, see
.
■
When a login fails, see
Note –
In this manual, the window of the XSCF Shell terminal is called the XSCF
console.
5.2.2
Operation From a Terminal Connected to the
Serial Port
This section describes how to log in from a terminal connected to the serial port.
1. After the terminal is connected to the serial port, press return on the terminal.
2. Enter a user account and password when prompted by XSCF.
3. Enter XSCF commands at the shell prompt (XSCF>) that is displayed after
login to XSCF.
The following is a login example: