FUJITSU SPARC M4000 - Manual (Page 181)

Chapter 2 Setting Up XSCF 2-125
Specifying the CPU Operational Mode
■
Command operation
1. Power off the domain.
2. Use the showdomainmode (8) command to specify the CPU operational mode.
XSCF> showdomainmode -d 0
Host-ID :0f010f10
Diagnostic Level :max
Secure Mode :on
Autoboot :on
CPU Mode :auto
3. Use the setdomainmode (8) command to set the CPU operational mode.
Specify SPARC64 VI compatible mode for CPU operational mode of domain
ID 0.
XSCF> setdomainmode -d 0 -m cpumode=compatible
Diagnostic Level :max -> -
Secure Mode :on -> -
Autoboot :on -> -
CPU Mode :auto -> compatible
The specified modes will be changed.
Continue? [y|n]:y
configured.
Diagnostic Level :max
Secure Mode :on (host watchdog: available Break-signal:non-receive)
Autoboot :on (autoboot:on)
CPU Mode :compatible
4. Use the showdomainmode (8) command to confirm that the CPU Mode is
compatible.
Note – Restart the domain to apply the settings to the domain. You may set the
initial diagnostic level, enable or disable the host watchdog function, break signal,
automatic boot, and CPU operational mode.