FUJITSU SPARC M4000 User Manual
Page 66
2-10
SPARC Enterprise Mx000 Servers XSCF User’s Guide • April 2008
17. Configure the domain settings.
• Display domain information and specify
the domain configuration. (DCL
displaying and settings (Note 1),
configuration policy settings (Note 2),
System board settings)
showboards
(8), showdcl(8), setdcl(8)
• Add or delete a system board.
addboard
(8), deleteboard(8)
(See
Section 2.2.11, “Domain Configuration”
Note –
(1) The Domain Component List (DCL) is definition data for the hardware
resources that constitute a domain. There is one DCL per the logical system board.
Each domain has up to 16 logical system boards. The DCL is used to add a hardware
resource that constitutes a domain and to display resource configuration
information. For details on the DCL, see
Section 2.2.11, “Domain Configuration” on
, the Administration Guide, and the Dynamic Reconfiguration User’s Guide.
Note –
(2) In the configuration policy settings, a degradation range applicable to
errors detected during initial hardware diagnosis can be specified.
18. Configure the domain mode settings.
• Display and make the domain mode
settings. (Break signal sending on/off,
enable/disable Host watchdog
monitoring, automatic boot setting, CPU
operational mode)
showdomainmode
(8), setdomainmode(8)
(See
Note –
The automatic boot setting enables you to specify whether to boot the Solaris
OS, and sets the auto-boot? OpenBoot PROM variable to be either true or false.
19. Configure the Locale settings.
• Display and set the Locale.
showlocale
(8), setlocale(8)
(See
Section 2.2.14, “Locale Administration”
)