FUJITSU SPARC M4000 - Manual (Page 65)

Chapter 2 Setting Up XSCF 2-9
12. Configure the log archiving settings.
• Display log archiving settings and
configure log archiving.
showarchiving (8), setarchiving(8)
(See Section 2.2.8, “Log Archiving
Administration” on page 2-68 )
13. Configure the audit settings.
• Display audit settings and configure
auditing.
showaudit (8), setaudit(8)
(See Section 2.2.7, “Audit Administration”
on page 2-61 )
Note – The auditadm privilege is required for the audit settings.
14. Configure the SNMP settings.
• Display Agent settings and configure
Agent.
• Display and specify the notification
destination server.
showsnmp (8), setsnmp(8),
showsnmpusm (8), setsnmpusm(8),
showsnmpvacm (8), setsnmpvacm(8)
(See Section 2.2.9, “SNMP Administration”
on page 2-73 )
15. Make the settings for using the remote maintenance service.
Note – This document does not provide details on the remote maintenance service
functions. For details on making settings and using the remote maintenance service,
refer to the manual describing the remote maintenance service listed in
“SPARC
Enterprise Mx000 Servers Documentation” on page xx .
16. Configure the system board settings.
• Display and set a memory mirror mode.
• Display and specify system boards
separately from the XSB. (Uni-XSB or
Quad-XSB displaying and settings.)
showfru (8), setupfru(8)
(See Section 2.2.12, “System Board
Configuration” on page 2-113 )