Lenovo ThinkServer RD650 - Manual (Page 149)

To install or replace a hot-swap drive, do the following:
1. Review the following installation rules:
• When you install drives, follow the order of the drive bay numbers. See “Front view of the server” on
page 17 to locate the drive bays in your server.
• For RAID configuration, the drives must be the same type with the same capacity if they are within a
single RAID array. For more information, see “Configuring RAID” on page 62.
• For drives with different capacities, install the drives following the order from the lowest capacity to
the highest capacity.
2. Do one of the following:
• If you are installing a new drive, locate the appropriate drive bay. Then, press the circled area 1 to
open the handle of the dummy tray.
1
1
Figure 113. Opening the handle of a dummy tray
• If you are replacing a drive, locate the drive you want to replace and press the release button 1 to
open the handle of the drive.
Chapter 6 . Replacing hardware 135