Yaskawa JAPMC-MC2300 - Manual (Page 35)

2.3 Mounting/Removing SVA-01 Modules
2.3.2 Removing SVA-01 Modules for Replacement
2-9
2
Settings and Installation
3.
Remove the SVA-01 Module from the mounting base.
Pull the top of the panel of the SVA-01 Module towards you to remove it. A notch on the SVA-01 Module will be
visible from the gap in the cover. Hook the round knob on the battery cover, shown in the diagram, into the notch
in the SVA-01 Module.
While holding the battery cover as shown in the photograph, tilt the cover back with the knob as the pivot point to
disconnect the Module. The Module should move forward out of the case.
4. Pull out the SVA-01 Module.
While holding both the top and bottom of the Module, pull the Module out straight towards you. Hold the Mod-
ule by its edges and do not touch any components on the Module.
Place the Module in the bag provided with the initial shipment and store it in this bag.
Round Knob
Notch
Fulcrum
ΠA optional cover (JEPMC-OP2300) must be installed on the empty slot.