Yaskawa MP930 - Manual (Page 62)

3.2 Start and Stop Sequences
3 -3
3.2 Start and Stop Sequences
This section explains the start and stop sequences of the MP930. The methods of setting the DIP
switch, the types of self-diagnosis, and the indicator patterns are also explained.
3.2.1 DIP Switch Settings
The DIP switch on the CPU Module are used to control start and stop sequences. As shown in
Figure 3.2, there are six pins on the DIP switch on the CPU Module. Table 3.1 shows the func-
tion of each pin.
ON
12
3
4
5
6
→
Figure 3.2
Table 3.1 DIP Switch Pin Functions
No. Name Setting Function Default Setting
1 FLASH ON Used by the system Normally set to OFF.
OFF −
2 RUN ON User program operating Normally set to ON.
OFF User program stopped
3 INIT ON Number 4 ON: Memory clear
OFF: Programming Panel
port default
Normally set to OFF.
OFF Online
4 TEST ON Terminal (communications) mode Normally set to OFF.
OFF Online
5 Not used ON − Normally set to OFF.
OFF −
6 S.TST ON Used by the system Normally set to OFF.
OFF Online
3