HEIDENHAIN TNC 640 (34059x-02) - Manual (Page 645)

Functions of the TNC 640 and the iTNC 530 compared 19.5
19
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
645
Cycle TNC 640 iTNC 530
440, measuring an axis shift – X
441, Rapid probing (on TNC 640 partly possible with touch probe
table) – X
450, saving the kinematics X, option 48 X, option 48
451, measuring the kinematics X, option 48 X, option 48
452, preset compensation X, option 48 X, option 48
460, calibrating a TS on a sphere X X
461, calibrate TS length X X
462, calibration in a ring X X
463, calibration on stud X X
480, calibrating a TT X X
481, measuring/inspecting the tool length X X
482, measuring/inspecting the tool radius X X
483, measuring/inspecting the tool length and radius X X
484, calibrating the infrared TT X X
Comparison: Differences in programming
Function TNC 640 iTNC 530
Switching the operating mode
while a block is being edited Not permitted Permitted
File handling:
Save file function Available Available
Save file as function Available Available
Discard changes Available Available
File management:
Mouse operation Available Available
Sorting function Available Available
Entry of name Opens the
Select file pop-up
window
Synchronizes the cursor
Support of shortcuts Not available Available
Favorites management Not available Available
Configuration of column
structure Not available Available
Soft-key arrangement Slightly different Slightly different
Skip block function Available Available
Selecting a tool from the table Selection via split-screen menu Selection in a pop-up window
Programming special functions
with the SPEC FCT key Pressing the key opens a soft-key
row as a submenu. To exit the
submenu, press the SPEC FCT
key again; then the TNC shows
the last active soft-key row Pressing the key adds the soft-key
row as the last row. To exit the
menu, press the SPEC FCT key
again; then the TNC shows the
last active soft-key row