HEIDENHAIN TNC 640 (34059x-02) - Manual (Page 530)

Manual operation and setup
15.9 Datum Setting with 3-D Touch Probe
15
530
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
15.9 Datum Setting with 3-D Touch Probe
Overview
The following soft-key functions are available for setting the datum
on an aligned workpiece:
Soft key Function Page
Datum setting in any axis with 530
Setting a corner as datum 531
Setting a circle center as datum 533
Center line as datum 533
Datum setting in any axis
Select the probing function: Press the PROBING
POS soft key
Move the touch probe to a position near the touch
point
Use the soft keys to select the probe axis and
direction in which you want to set the datum, such
as Z in direction Z–
Start the probing procedure: Press the machine
START button
Datum: Enter the nominal coordinate and confirm
your entry with the SET DATUM soft key, See
"Writing measured values from the touch probe
cycles in a datum table", page 520
To terminate the probe function, press the END
soft key
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.