HEIDENHAIN TNC 640 (34059x-02) User Manual
Page 37
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
37
14 Programming: Turning Operations............................................................................................... 459
14.1 Turning Operations on Milling Machines (Software Option 50)......................................................460
Introduction.............................................................................................................................................460
14.2 Basis Functions (Software Option 50)............................................................................................... 461
Switching between milling/turning mode of operation.......................................................................... 461
Graphical display of turning operations..................................................................................................463
Program spindle speed.......................................................................................................................... 464
Feed rate................................................................................................................................................ 465
Tool call...................................................................................................................................................465
Tool compensation in the program........................................................................................................ 466
Tool data................................................................................................................................................. 467
Tool tip radius compensation TRC......................................................................................................... 472
Recessing and undercutting...................................................................................................................473
Inclined turning.......................................................................................................................................479
14.3 Unbalance Functions........................................................................................................................... 481
Unbalance while turning........................................................................................................................ 481
Measure Unbalance cycle...................................................................................................................... 483