HEIDENHAIN TNC 640 (34059x-02) - Manual (Page 204)

Programming: Programming contours
6.3 Approaching and departing a contour
6
204
TNC 640 | User's Manual
HEIDENHAIN Conversational Programming | 5/2013
Departing in a straight line with tangential
connection: DEP LT
The tool moves on a straight line from the last contour point P
E
to
the end point P
N
. The line lies on the extension of the last contour
element. P
N
is separated from P
E
by the distance LEN.
Program the last contour element with the end point P
E
and
radius compensation
Initiate the dialog with the APPR/DEP key and DEP LT soft key:
LEN: Enter the distance from the last contour
element P
E
to the end point P
N
Example NC blocks
23 L Y+20 RR F100
Last contour element: PE with radius compensation
24 DEP LT LEN12.5 F100 Depart contour by LEN=12.5 mm
25 L Z+100 FMAX M2 Retract in Z, return to block 1, end program
Departing in a straight line perpendicular to the last
contour point: DEP LN
The tool moves on a straight line from the last contour point P
E
to
the end point P
N
. The line departs on a perpendicular path from the
last contour point P
E
. P
N
is separated from P
E
by the distance LEN
plus the tool radius.
Program the last contour element with the end point P
E
and
radius compensation
Initiate the dialog with the APPR/DEP key and DEP LN soft key:
LEN: Enter the distance from the last contour
element to P
N
. Important: Enter LEN with a
positive value.
Example NC blocks
23 L Y+20 RR F100 Last contour element: PE with radius compensation
24 DEP LN LEN+20 F100
Depart perpendicular to contour by LEN=20 mm
25 L Z+100 FMAX M2 Retract in Z, return to block 1, end program