beautypg.com

HEIDENHAIN TNC 640 (34059x-02) User Manual

Page 30

background image

Contents

30

TNC 640 | User's Manual

HEIDENHAIN Conversational Programming | 5/2013

9.12 Preassigned Q parameters.................................................................................................................. 336

Values from the PLC: Q100 to Q107.....................................................................................................336

Active tool radius: Q108.........................................................................................................................336

Tool axis: Q109.......................................................................................................................................336

Spindle status: Q110.............................................................................................................................. 337

Coolant on/off: Q111...............................................................................................................................337

Overlap factor: Q112.............................................................................................................................. 337

Unit of measurement for dimensions in the program: Q113.................................................................337

Tool length: Q114................................................................................................................................... 337

Coordinates after probing during program run.......................................................................................338

Deviation between actual value and nominal value during automatic tool measurement with the TT

130.......................................................................................................................................................... 338

Tilting the working plane with mathematical angles: rotary axis coordinates calculated by the TNC.....338

Measurement results from touch probe cycles (see also User’s Manual for Cycle Programming)........ 339

9.13 Programming examples.......................................................................................................................341

Example: Ellipse..................................................................................................................................... 341

Example: Concave cylinder machined with spherical cutter.................................................................. 343

Example: Convex sphere machined with end mill.................................................................................345