Grass Valley CRSC v.3.2 - Manual (Page 85)

73
CRSC
User’s Guide
Buttons
At the very bottom of the page are 4 buttons:
• Refresh Summary.
Click Refresh Summary at any time to be sure that you are viewing the most current infor-
mation.
• Undo Last Take.
Click Undo Last Take if you make a mistake and perhaps forget what you did.
The ‘Undo Last Take’ can undo multiple takes — one at a time, the most recent one first.
• Diagonal Take.
Click Diagonal Take to perform a diagonal take. See Diagonal Takes on page 79 for informa-
tion.
• Range Take.
Click Range Take to perform a diagonal take. See Range Takes on page 83 for information.
The Table View
You can use the table view to perform takes and to see lock status and take status for each of the
router’s outputs. The columns of the table are as follows:
In the table view, you can select a range of outputs (multiple contiguous rows) for the purpose
of a copy or a range take. See
Copying and Pasting Crosspoint Data on page 76. It is not possible
to make a disjoint selection.
Column Description
Output Each row in the table is a router output. The number in the output column identifies
the output.
Input The input that has been routed to the output
Locked A lock icon in this column means the output is locked. If a field of the column is clear,
the output is unlocked.
Lock ID An identification number for the user that applied a lock.
Status When a take is performed, the column indicates the success of the take.
You can hover your mouse over an entry in the column to show the time the take
occurred and a summary of the take.
Typical status results are “Success” or “Destination Locked.”