Using the router levels page – Grass Valley CRSC v.3.2 User Manual
Page 43
31
CRSC
User’s Guide
Using the Router Levels Page
At the top of the page, the ‘Setup Crosspoint Ranges for Levels’ table displays all levels currently
added to the selected subnet and lets you add, delete, and change levels as needed.
In the lower section of the page the ‘Network Frame Summary’ has two tabs
—
‘Routers’ and ‘All
CR Frames’
—
that list the devices detectable by your PC. The ‘Routers’ tab lists only CR Series
routers. The ‘All CR Frames’ lists all CR Series devices.
The ‘Setup Crosspoint Ranges for Levels’ table display the following information for each level:
The ‘Network Frame Summary’ presents the following information:
None of this information is editable.
Column
Description
Level Number
A number assigned to the level. The number must be unique and from 1
to 250. The numbers are automatically generated.
Level Name
A name you assign to the level. The name is limited to 16 characters.
Router Name
The name of the router that contains the level. The router names are not
editable.
Signal Type
The type of signal switched on that level. See
Physical Input Start
Use these fields to define the physical start and endpoints of the level
within the router.
Physical Input End
Physical Output Start
Physical Output End
Controller Source Start
I/O numbering in a remote panel might not match the physical I/O num-
bers of the router. Use these fields to map the router’s numbering to the
NV9000’s numbering.
(The remote panel’s source end and destination end values are derived
from the physical start and end and the source start and destination start
values.)
If there is no remote panel in your system, you can ignore these fields.
Controller Destination Start
Tab
Column
Description
Routers
Name
The name of the compact router.
Frame Type
The type of router.
Level(s)
Level numbers associated with the router. Each level is assigned a
unique number.
IP Address
IP address currently assigned to the device.
Subnet Mask
Subnet mask currently assigned to the device.
All CR Frames
Frame Type
The type of router or remote panel.
Level(s)
Level numbers associated with routers.
Subnet Mask
Subnet mask currently assigned to the device.