Comtech EF Data CIM-300L - Manual (Page 87)

CiM-300L IP Enabled Satellite Modem Rev. 1
Front Panel Menus CD/CIM300L.IOM
61
DISPLAY SELECTIONS/DESCRIPTION
REV. EMULATION
CURRENT_VERSION
Programs an emulation mode of a previous
Bse modem M&C functional revision. This
allows the user to select the CURRENT
VERSION or FUNCTIONAL X.
CURRENT_VERSION
FUNCTION VERSION X
(X = Rev. Emulation desired)
Notes:
1. Programming a current version (default)
allows all features and options (if
installed) to operate normally.
2. Programming a FUNCTIONAL version (X)
eliminates any changes that affect the
later version. Only functional changes are
affected by the revision emulation feature.
3. A correction change (e.g., VER 3.1.2)
remains fixed in accordance with the
latest version. Since the revision
emulation default is the current version,
program the functional version at the start
of each operation.
4. The revision emulation feature does not
affect some interface changes for the
direct operation of the modem
(Configuration save/recall, test mode
screen in the Utility/System, all factory
setup modes, etc.).
MODEM OPTIONS
HIGH POWER
(Status Only)
HIGH POWER
(0 or +)
HIHG STABILITY (0 or +)
VITERBI (- or +)
SINGLE RATE (- or +)
LOW RATE (- or +)
FULL RATE (- or +)
CARD #1 PCB (x or +)
CARD #3 PCB (x or +)
CARD #3 PCB (x or +)
8PSK 2/3 (- or +)
TX ONLY (0 or +)
RX ONLY (0 or +)
0QPSK (- or +)
TX/RF L-BAND (0 or +)
CARD #1 TYPE
NOT INSTALLED
IP 01