Comtech EF Data CIM-300L - Manual (Page 102)

CiM-300L IP Enabled Satellite Modem Rev. 1
Serial Remote Control CD/CIM300L.IOM
76
Parameter Type Protocol Description
AUPC
Remote
Carrier Loss
Action Command:
Response:
Status:
Response: >add/RCL_xxxx'cr''lf']
>add/RCL_xxxx'cr''lf']
Where: xxxx = HOLD, NOM, or MAX (power level setting when
remote carrier loss).
Remote
Modem
AUPC
Commands
Notes: 1. Always wait 3 seconds between consecutive remote
modem command/status polls.
2. If Local AUPC is not enabled, status commands will
return last known condition. They will also request status
from the remote modem. This allows a second request to
return proper status.
Remote
AUPC
Enable Command:
Response:
>add/RPC_xxx'cr''lf']
Where: xxx = ON or OFF (remote AUPC enable).
Remote
Interface
Substitution
Pattern Command:
Response:
Status:
Response: >add/RISP_xxx'cr''lf']
>add/RISP_xxx'cr''lf']
Where: xxx = ON or OFF (remote transmit 2047 pattern enable).
Note: Transmit 2047 Pattern.
Remote
Interface
Baseband
Loopback Command:
Response:
Status:
Response: >add/RBBL_xxx'cr''lf']
>add/RBBL_xxx'cr''lf']
Where: xxx = ON or OFF (remote baseband loopback enable).
Remote
Interface
Read Error
Status Command:
Response:
Example:
Command:
Response: >add/RRES_nE-e'cr''lf']
>add/RRES_2E-6'cr''lf'] Where:
n = 1 to 9 (error rate number).
e = 2 to 6 (exponent).
Note:
Received 2047 Pattern.
This command returns 2047 BER from the remote AUPC modem.
If data is not valid, the message 'No_Data' is returned in lieu of
BER data.