Status commands/responses, Modulator configuration status, 5 status commands/responses – Comtech EF Data CIM-300L User Manual
Page 103
![background image](https://www.manualsdir.com/files/778889/content/doc103.png)
CiM-300L IP Enabled Satellite Modem
Rev. 1
Serial Remote Control
CD/CIM300L.IOM
77
5.5 S
TATUS
C
OMMANDS
/R
ESPONSES
5.5.1 M
ODULATOR
C
ONFIGURATION
S
TATUS
Parameter
Type
Protocol
Description
Modulator
Config.
Status
Command:
Response:
RF_xxx'cr'
MF_nnn.nnnnnnn'cr'
MR_nnnn_mmmm.mmm'cr'
AMRA_nnnn_mmmm.mmm'cr'
AMRB_nnnn_mmmm.mmm'cr'
AMRC_nnnn_mmmm.mmm'cr'
AMRD_nnnn_mmmm.mmm'cr'
AMRV_nnnn_mmmm.mmm'cr'
MPO_snn.n'cr'
MOP_snn.n'cr'
SE_xxx'cr'
DENC_xxx'cr'
MT_xxxxx'cr'
MET_xxx'cr'
COM_xxxxxx'cr'
MRC_xxx'cr'
MSR_xxx'cr'
RSEN_xxx'cr'
TDA_xxx'cr'
TRSI_xx'cr'
T310_xxx'cr''lf']
RF Output
Modulator Frequency
Modulator Rate
Preset 'A' Assignment
Preset 'B' Assignment
Preset 'C' Assignment
Preset 'D' Assignment
Preset 'V' Assignment
Modulator Power Offset
Modulator Output Power
Scrambler Enable
Differential Encoder
Modulator Type
Modulator Encoder Type
Carrier Only Mode
Modulator Reference Clock
Modulator Spectrum Rotation
Reed-Solomon Encoder
Transmit BPSK Data Ordering
TX Reed-Solomon Interleave Value
TX 8PSK 2/3 IESS-310 Operation
The modulator configuration status command causes a block of
data to be returned by the addressed modem. The block of data
reflects the current configuration status of the modulator module.
Additional configuration status of new options and features will
always be appended to the end.
Modulator
Coder
Config.
Program
Status
Command:
Response:
ITOT_xxxxx'cr'
MOM_xxxxxxx'cr'
MF_nnn.nnnnnn'cr'
MR_nnnn_mmmm.mmm'cr'
MPO_snn.n'cr'
MOP_snn.n'cr' (Note
4)
SE_xxx'cr'
DENC_xxx'cr'
MRC_xxx'cr'
MSR_xxx'cr'
RSEN_xxx'cr'
TDA_xxx'cr'
COM_xxxxxx'cr'
ODU_ xxx'cr'
ODUR_ xxx'cr'
ODUL_ xxxx'cr’
ODUH_ x'cr’
TRSI_xx'cr'
RF_xxx'cr''lf']
Interface Transmit Overhead Type
Modem Operation Mode
Modulator Frequency
Modulator Rate
Modulator Power Offset
Modulator Output Power
Scrambler Enable
Differential Encoder
Modulator Reference Clock
Modulator Spectrum Rotation
Reed-Solomon Encoder
Transmit BPSK Data Ordering
Carrier Only Mode
ODU (ON/OFF)
ODU Remote Mode
ODU Low Threshold
ODU High Threshold
TX Reed-Solomon Interleave Value
RF Output (ON/OFF)
Note:
This command is used by the EF Data M:N protection