Comtech EF Data CIM-300L - Manual (Page 277)

CiM-300L IP Enabled Satellite Modem Rev. 1
SNMP CD/CIM300L.IOM
251
11.5 C
I
M 300L P
RIVATE
MIB
11.5.1 C
I
M 300L O
BJECTS
G
ROUP
11.5.1.1 S
YSTEM
I
NFORMATION
Table 11-36. ARP Configuration Subgroup OIDs
OID Description
cim300LEquipmentType
Unit’s equipment type and software version.
cim300LUnitSerialNumber Unit’s serial number and the serial numbers of up to 3 Cards if
they are installed.
cim300LFirmwareBoot Unit’s boot M&C software version, firmware number, firmware
dash number, and firmware revision.
cim300LFirmwareMnC M&C software version number, firmware version number,
firmware dash number, and firmware version.
cim300LFirmwareBULK DATA ROM firmware number, firmware dash number, and
firmware revision.
cim300LModemOptions Availability (installed/not installed) of the following options: High
Power, High Stability, Asymmetrical Loop Timing, Viterbi
Encoder/Decoder, Sequential Encoder/Decoder, Single
Code/Data Rate, Low Rate Variable, Full Rate Variable, Card #1
Installed, Card #2 Installed, Card #3 Installed, 8PSK 2/3 Code
Rate, TX Only Operation, RX Only Operation, OQPSK 1/2, 3/4,
7/8.
cim300LCard1Type Tells what card 1 is installed.
cim300LCard2Type Tells what card 2 is installed.
cim300LCard3Type Tells what card 3 is installed.
cim300LCard1Options Tells the card 1 options.
cim300LCard2Options Tells the card 2 options.
cim300LCard3Options Tells the card 3 options.
cim300LStateOfProduct Product address, data format, baud rate, communication type,
and IP Address.
cim300LDeviceTime Device time. Current time is in hh:mm:ss format.
cim300LDeviceDate Device date. Current date is in mm/dd/yy format.
cim300LOperationMode Can be set to:
1 TX Only
2 RX Only
3 Duplex
cim300LModemType Can be set to:
1 Custom
2 AUPC