Cim 1 configuration, M 1 c, Ip a – Comtech EF Data CIM-300L User Manual
Page 501
CiM-300L IP Enabled Satellite Modem
Rev. 1
Cim IP Module Checkout
CD/CIM300L.IOM
475
12.2.7
C
I
M 1 C
ONFIGURATION
CiM has 2 data interfaces - a LAN interface and a WAN interface. The LAN interface is
a 10/100baseT Ethernet port (fei0). The WAN interface is the serial synchronous HDLC
interface (hdl0). The Ethernet MAC address is factory assigned and cannot be changed.
12.2.7.1
S
ETTING
IP A
DDRESS
(
ES
)
Step Description
1
From the Main Menu select Interface Configuration sub-menu.
2
From the Interface Configuration Menu select Ethernet Interface (fei0)
3
Set IP Address to 172.16.10.10
4
Set Subnet Prefix Length to 24
5
From the Interface Configuration Menu select Satellite/HDLC Interface (hdl0).
6
Set IP Address to 10.1.1.1
7
Set Subnet Prefix Length to 24
8
Set RX – Enable/Disable and TX – Enable/Disable to Enable.
9
From Receive HDLC Channel Address menu set HDLC Addr 1 to 1 (0x0001)
The other parameters can be left to their factory default settings.
At this point you should be able to ping CiM 1 from PC 1:
10
ping 172.16.10.10
11
ping 10.1.1.1
12.2.7.2 R
OUTE
T
ABLE
Step Description
1
From Main Menu, select Route Table sub-menu.
2
Enter 1 to configure the first route
3
Enter a suitable name
4
Set IP Address to 172.17.10.0
5
Set Number of Subnet Bits to 24
6
Enter the next hop IP address which is CiM 2’s HDLC IP Address, 10.1.1.2
12.2.7.3 S
AVE
C
ONFIGURATION
Save parameters to permanent storage.