Comtech EF Data CIM-300L - Manual (Page 152)

CiM-300L IP Enabled Satellite Modem Rev. 1
AUPC CD/CIM300L.IOM
126
To setup the modem for the self-monitoring operation, enter the Local Modem AUPC
menu located under the Utility Modem Type menu and select On. This enables the
Configuration: Local AUPC menu to permit adjustment of the AUPC parameters
described in Table 8-1.
Notes:
1 Comtech EF Data does not recommend increasing the power to the satellite without
consulting with the satellite controller.
2 Be careful not to set carrier output too high when there is a loss of carrier due to
severe weather and the CL loss action is set to Maximum.
3 Do not use the distant end RX signal to compensate for local rain fade unless
allowances are made for a narrow window for TX level changes.
8.1.4 F
RONT
P
ANEL
O
PERATION
For information on the additional front panel operations that are specific to the ASYNC
interface. The following menus are affected:
! Configuration Local AUPC
! Remote AUPC Configuration
! Remote AUPC Monitor
Table 8-2. AUPC Default Settings
Local AUPC
AUPC ENABLE OFF Target Noise 6.0 dB
Nominal Power +0.0 dBm Tracking Rate 0.5 dB/MIN
Minimum Power -20.0 dBm Local CL Action Hold
Maximum Power +5 dBm Remote CL Action Hold