Comtech EF Data CIM-300L - Manual (Page 117)

CiM-300L IP Enabled Satellite Modem Rev. 1
Serial Remote Control CD/CIM300L.IOM
91
Bulk Consol.
Status
(continued)
Parameter
Number Parameter Name
(Command Reference)
Description
(Note 3)
(Note 4)
(Note 7)
(Note (8)
(Note 7)
(Note 7)
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
RTS TX-IF Control Mode
(ref. 'RTSM_' command).
CTS Delay Time
(ref. 'CTSD_' command).
Carrier Only Mode
(ref. 'COM_' command).
IDR TX ESC Type
(ref. 'TET_' command).
IDR RX ESC Type
(ref. 'RET_' command).
TX Reed-Solomon Interleave Value
(ref. 'TRSI_' command).
RX Reed-Solomon Interleave Value
(ref. 'RRSI_' command).
reserved null field.
reserved null field.
reserved null field.
TX 8PSK 2/3 IESS-310 Operation
(ref. 'T310_' command).
RX 8PSK 2/3 IESS-310 Operation
(ref. 'R310_' command).
Flex Mux Channel #1 Enable
(ref. "TCEN_1" command).
TX Flex Mux Channel #1 Data Rate
(ref. "TCDR_1" command).
TX Flex Mux Channel #2 Enable
(ref. "TCEN_2" command).
TX Flex Mux Channel #3 Enable
(ref. "TCEN_3" command).
p107 = n, where 'n' is '0' (off) or '1' (on).
p108 = nn, CTS delay time in seconds.
p109 = n, where 'n' is '0' (OFF),'1' (CENTER-CW), '2' (DUAL-
CW), '3' (OFFSET-CW).
p110 = n, where 'n' is '0' (AUDIO), '1' (DATA).
p111 = n, where 'n' is '0' (AUDIO), '1' (DATA).
p112 = nn, Interleave value.
p113 = nn, Interleave value.
p117 = n, where 'n' is '0' (off) or '1' (on).
p118 = n, where 'n' is '0' (off) or '1' (on).
p119 = n, where 'n' is '0' (Disabled), '1' (D&I), or '2' (for T1/E1)
operation.
p120 = nnnn.n, where 'nnnn.n' is the data rate in Kbps.
p121 = n, where 'n' is '0' (Disabled), '1' (Enabled).
p122 = n, where 'n' is '0' (Disabled), '1' (Sync RS422), '2' (Async
RS422), '3' (Sync RS232), '4' (Async RS232), or '5' (AUPC
operation).