Comtech EF Data CIM-300L - Manual (Page 48)

CiM-300L IP Enabled Satellite Modem Rev. 1
Operation CD/CIM300L.IOM
22
REMOTE ETHERNET
10/100
CONSOLE
J6 V.35/RS422
J7 FAULT ALARM J10
AUX J9
CP1
TX/IF OUT
RX/IF IN
CP3
CP2
EXT REF
RX/IF IN
CP3 AC INPUT REMOTE J9 AUX
J6 V.35/RS422
J7 FAULT
J10 ALARM
EXT REF
CP2
TX/IF OUT
CP1
10/100
ETHERNET
GROUND STUD
CONSOLE
Figure 3-2. Rear Panel
3.1.1 F
RONT
P
ANEL
O
PERATION
The front panel provides a menu driven, easy to operate, user interface that provides
control of all modem parameters plus selection of the IP address and network prefix
length. On the front panel of the unit, there are a keypad, the Vacuum Fluorescent
Display (VFD), and eight LED indicators. The user enters data via the keypad, and
messages are displayed on the VFD. The LEDs indicate, in a summary fashion, the status
of the unit. Refer to Chapter 4 for detailed operations.
3.1.2 S
ERIAL
R
EMOTE
C
ONTROL
O
PERATIONS
The CiM-300L modem provides a standard serial (RS-232, RS-485 4-wire, or RS-485 2-
wire) interface that can be used only for monitor and control of CiM-300L modem
parameters (Monitor and Control of the CiM-300L IP parameters is provided separately
via the Console Port interface). Access to this application is provided via the ‘Remote
Control B’ (DB9) port on the back of the modem. Refer to Chapter 5 for detailed
operations using this interface.
3.1.3 S
ERIAL
C
OMMAND
L
INE
I
NTERFACE
(CLI) O
PERATIONS
The CiM-300L modem provides a serial (RS-232) command line interface that can be
used only for monitor and control of CiM-300L IP parameters (Monitor and Control of
the CiM-300L modem parameters is provided separately via the ‘Remote Control B’
port). Access to this application is provided via the ‘Console Port’ (RJ-11) port on the
back of the modem. Refer to Chapter 11 for detailed operations using this interface.
3.1.4 T
ELNET
O
PERATIONS
The CiM-300L modem provides a Telnet interface with an embedded, easy to use, multi-
level, menu system that can be used to monitor and control all CiM-300L modem and IP
parameters. Access to this application is provided via the 10/100 BaseT IP interface (RJ-
45). Refer to Chapter 11 for detailed operations using this interface.