Table 11-26. route table group oids, Table 11-27. route table oids, 13 r – Comtech EF Data CIM-300L User Manual
Page 267
CiM-300L IP Enabled Satellite Modem
Rev. 1
SNMP
CD/CIM300L.IOM
241
11.4.1.13 R
OUTE
T
ABLE
G
ROUP
Note: In order for the CiM-300L to properly pass packets over the satellite interface, the user
MUST provide the appropriate IP to HDLC address mapping in the ARP table. Please
see the ARP Configuration Group for more details.
Table 11-26. Route Table Group OIDs
OID Description
cimGlobalQosEnable
Allows an operator to view if the QOS feature is enabled or
disable.
The cimIpRouteTable allows a user to define how the packets that the CiM-300L
receives are routed. By this table, an operator can define the minimum QOS bandwidth
and maximum QOS bandwidth for a route. A user can also define which DES key to use
for a route.
Table 11-27. Route Table OIDs
OID Description
cimIpRouteIndex
Sequential number that corresponds to the row index in the
route table. The route index starts at 1.
cimIpRouteName
Name assigned by the user to reference the route. The
assigned name cannot contain any white space and must be
unique.
cimIpRouteDestAddress
Destination IP address for the route.
cimIpRouteDestMaskLen
Length of the network portion of the subnet mask.
cimIpRouteNextHopAddress
IP address where the packet will be routed for further
processing. The Next Hop IP Address must be on the same
subnet as either the Ethernet or Satellite interfaces.
cimIpRouteMulticastOptions
Allows a user to specify if multicast packets will be routed
from the Ethernet to Satellite or Satellite to Ethernet.
cimIpRouteMulticastOptions
This OID can be set to:
1 No
Routing
2
Eth To Sat Routing
3
Sat To Eth Routing
4
Sat To Eth And Eth To Sat Routing
Note: The
“cimIpRouteMinQosBandwidth” and “cimIpRouteMaxQosBandwidth” OIDs will only
be accessible if the QOS FAST feature has been purchased and activated. Otherwise, GETS
will return zero and sets will return an error.
cimIpRouteMinQosBandwidth Establishes a guaranteed minimum data rate that a route
must support. A value of 0 implies that a route is not
guaranteed any bandwidth. The minimum QOS bandwidth
should be in multiples of 8 Kbps.