Comtech EF Data CIM-300L User Manual
Page 110
CiM-300L IP Enabled Satellite Modem
Rev. 1
Serial Remote Control
CD/CIM300L.IOM
84
Parameter
Type
Protocol
Description
Reed-
Solomon
Unavailable
Seconds
Command:
Response:
MM/DD/YYYY'cr'
UNA_xxx'cr''lf']
Unavailable Seconds (FLT/OK)
Bulk Consol.
Analog
Status
Command:
Response:
This command is similar to the 'BCS_' command, but returns
modem analog parameters. Additional status of new options and
features will always be appended to the end.
Where 'pn' is the last parameter returned.
Parameter
Number
Parameter Name
(Command Reference)
Description
1
2
3
4
5
6
7
Receive Signal Level
(ref. 'RSL_' command).
Raw BER
(ref. 'RBER_' command).
Corrected BER
(ref. 'CBER_' command).
Interface Read Error Status
(ref. 'IRES_' command).
EB/NO
(ref. 'EBN0_' command).
Buffer Fill Status
(ref. 'IBFS_' command).
LNB Current
p1 = xsnn.n, receive signal level in dBm.
p2 = xm.mE-ee.
p3 = xm.mE-ee.
p4 = tttt_xm.mE-ee.
p5 = xnn.n, EB/NO in dB.
p6 = nn%, buffer fill status.
P7 = nnn, LNB Current
Note: Parameters 2 through 6 are dependent on carrier acquisition, if the decoder is not locked empty data blocks are returned (,,,,,).
Bulk Consol.
Status
Command:
Response:
This command causes bulk modem status to be returned. To
reduce the length of the response, message parameter data are
returned without identifiers. However, parameter identification can
be determined by order of return. Each status parameter is
terminated with a ',' (comma) except for the last parameter which
has the standard message termination sequence ('cr''lf']). Most of
the data returned is formatted the same way as the single
command status request (refer to the appropriate portions of this
document in preceding sections). Additional configuration status
of new options and features will always be appended to the end.
Where 'pn' is the last parameter returned.
Parameter
Number
Parameter Name
(Command Reference)
Description