beautypg.com

Comtech EF Data CIM-300L User Manual

Page 106

background image

CiM-300L IP Enabled Satellite Modem

Rev. 1

Serial Remote Control

CD/CIM300L.IOM

80

Parameter

Type

Protocol

Description

CONF_xxx'cr'
LNB_xxx’cr’
SFLT_xx'cr''lf']

Configuration (OK/FLT)
LNB (OK/FLT)
Number of stored faults logged (0 to 10)

Common
Equipment
Status

Command:
Response:

>add/CES_'cr'
M&C_xxx'cr'
INT_xxx'cr'
BAT_xxx'cr'
+5_xxx'cr'
+12_xxx'cr'
-12_xxx'cr'
ST_xxx'cr'
MODE_xxxxxx'cr'
SFLT_xx'cr''lf']



Monitor & Control Module (OK/FLT)
Data Interface/Overhead Module (OK/FLT)
Battery/Clock (OK/FLT)
+5V Power Supply (OK/FLT)
+12V Power Supply (OK/FLT)
-12V Power Supply (OK/FLT)
Self Test (OK/FLT)
Mode (LOCAL or REMOTE)
Number of stored faults logged (0 to 10)

The common equipment status command causes a block of data
to be returned which indicates the status of the common
equipment.

5.5.3 E

RROR

P

ERFORMANCE

Parameter

Type

Protocol

Description

Raw BER

Command:
Response:

>add/RBER_xm.mE-ee'cr''lf']

Where:

x = < or > (data modifier to indicate that the error rate is less than
or greater than the returned value).

m.m = 1.0 to 9.9 (error rate mantissa).

ee = 1 to 99 (error rate exponent).

Notes: 1. The 'x' (< or >) parameter is only returned if the error

rate has exceeded the computational resolution of the
system.

2. No Data' is returned if the error rate cannot be
calculated.

3. 'Sampling' is returned if not enough data is currently
available to calculate the error rate.

Corrected
BER

Command:
Response:

>add/CBER_xm.mE-ee'cr''lf']

Where:

x = < or > (data modifier to indicate that the error rate is less than
or greater than the returned value).

m.m = 1.0 to 9.9 (error rate mantissa).

ee = 1 to 99 (error rate exponent).

Notes: 1. The 'x' (< or >) parameter is only returned if the error

rate has exceeded the computational resolution of the
system.

2. 'No Data' is returned if the error rate cannot be
calculated.

3. 'Sampling' is returned if not enough data is currently
available to calculate the error rate.