Comtech EF Data CIM-300L - Manual (Page 272)

CiM-300L IP Enabled Satellite Modem Rev. 1
SNMP CD/CIM300L.IOM
246
11.4.1.15 R
EDUNDANCY
G
ROUP
Table 11-31. Redundancy OIDs
OID Description
cimCurrentRedundantState Displays if the modem is Online and Offline. The
Online modem is the one that will process traffic.
The Offline modem monitors the health of the
online unit and will take over if it detects a
failure.
cimLocalUnitManagementIpAddress IP Address for the Ethernet Interface for the
Local Unit.
cimRedundantUnitManagementIpAddress IP Address for the Ethernet Interface of the
Remote Unit.
cimRedundantTrafficIpAddress Traffic IP address will always be active on the
Online Modem. When a fault occurs the traffic
IP address will float between the two redundant
modems.
cimRedundantTrafficSubnetMaskLen This is the length of the traffic IP address and
can float between the two redundant modems
depending on if a failure occurs.
cimForceUnitOffline Forces a redundant switchover so that if the
modem is online it will transition to offline and
stop processing traffic. If the modem is already
offline, then this command will be ignored.
11.4.1.16 O
PERATION AND
M
AINTENANCE
G
ROUP
Table 11-32. Operation and Maintenance Subgoup OIDs
OID Description
cimAppVersion Displays the CiM Software’s name, version, and date.
cimSaveConfiguration Allows a user to save the current configuration of the CiM-300L
to permanent storage.
cimReset Allows a user to reboot the modem. It has the same logical effect
of power-cycling the unit.