Zilog Z8F0130 - Manual (Page 135)

UM013037-1212 Project Menu
Zilog Developer Studio II – Z8 Encore!
User Manual
111
software debug tool that does not require the existence of physical hardware. Currently,
the debugger supports debug tools for the Z8 Encore! simulator, the USB Smart Cable, the
serial Smart Cable, and the Ethernet Smart Cable.
Use Page Erase Before Flashing
Select the Use Page Erase Before Flashing checkbox if you want the internal Flash to
be page-erased. Deselect this checkbox if you want the internal Flash to be mass-erased.
Target
Select the appropriate target from the Target list box. The selected target name is displayed
in the Debug output window after you click the
Reset button (available from the Build
toolbar or Debug toolbar).
Setup
Click Setup in the Target area to display the Configure Target dialog box.
The options displayed in the Configure Target dialog box depend on the CPU you selected
in the New Project dialog box (see the New Project section on page 49) or the General
page of the Project Settings dialog box (see the General Page section on page 69).
1. Select the internal or external clock source.
Figure 67. Configure Target Dialog Box
Note: