Zilog EZ80190 User Manual
Zdi232zpak2zpk zpak ii debug interface module, Introduction, Installing and configuring zpak ii
ZiLOG Worldwide Headquarters • 532 Race Street • San Jose, CA 95126
Telephone: 408.558.8500 • Fax: 408.558.8300
ww
Introduction
This document describes how to setup and use the ZiLOG ZPAK II Debug Interface Mod-
ule with your ZiLOG development kit. The ZPAK II module enables a development PC
running ZDS II to communicate with a ZiLOG development kit. It also provides an Ether-
net interface to the development PC.
The kit includes:
•
ZPAK II module
•
DB9-to-ID10 serial cable
•
Keyed 40-conductor ribbon cable
•
Target Interface Module (TIM)
•
User Manual
•
CD-ROM with ZDS II software and additional documentation
Installing and Configuring ZPAK II
The ZPAK II module features an Ethernet interface and an RS-232 console port. Slight
modifications to your PC’s network configuration may be required for first-time use. Fol-
low the steps in this section to install and configure the ZPAK II module. See Figures 1
and 2.
Figure 1. Hardware Setup using an Ethernet Hub
ZPAK II
Development PC
eZ80
Development
Platform
eZ80
Development
Module
ZDI
TIM
5 VDC
9 VDC
RJ-45
RJ-45
RS-232
Ethernet
Hub
¤
¤
Development
Kit
ZDI232ZPAK2ZPK
ZPAK II Debug Interface Module
User Manual
UM016301-1003