KEYENCE IB Series - Manual (Page 73)

4-2 Basic Settings and Advanced Settings
4-21 IB-E
4
Set
ting V
a
rious
F
unct
ions
Auto bottom hold
When the internal measurement value (R.V.) falls below the specified trigger level, the
sampling begins. When it goes beyond the trigger level, the sampling finishes. When the
sampling finishes, the internal measurement value (R.V.) minimum during the sampling
period is held as a judgment value (P.V.).
The external input is not required.
*1 " 10. External Input" (page 4-29)
*2 After the power is turned on or reset is input, the judgment value (P.V.) is [-----] until
the judgment value (P.V.) is first held.
*3 While the timing input is ON, the sampling does not start. If the sampling is already in
process, it continues.
 Trigger level setting screen
When the Auto bottom hold is set, the display goes to the trigger level setting screen.
Press the  /  button on the trigger level setting screen to specify the trigger level.
" 1. Measurement Mode" (page 4-8)
Reference • The operation by the timing input is the same regardless of the " 6. Tim-
ing Input" (page 4-23) setting.
• After the sampling starts, if the internal measurement value (R.V.)
becomes [-----] before the sampling goes beyond the specified trigger
level, the sampling is automatically finished and the minimum value dur-
ing the sampling period is held as a judgment value (P.V.).
Display value
Time
Timing Input
Trigger level
Hysteresis
ON
OFF
Power ON or
Reset input*
1
*3
*2
Judgment value (P.V.)
Internal measurement
value (R.V.)
Item
Measurement
mode
Setting range Default value
Trigger level
% mode - 999.99 to 999.99 90.00
Dimension mode - 99.999 to 99.999 9.000
#WVQ2
LASER
BANK 0
1
2
3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
*.F
GO
HOLD CALC CHECK
LASER
BANK 0
1
2
3
HI
GO
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
V).X HOLD CALC CHECK
F'(.V
LASER
BANK 0
1
2
3
HI
GO
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
V)*;U HOLD CALC CHECK
Q((
LASER
BANK 0
1
2
3
HI
LO
R.V. ANALOG
HI SHIFT
ZERO SHIFT
TIMING LO
ALIGNMENT
&.;
GO
HOLD CALC CHECK
5. Hold function
Trigger level
setting screen Hysteresis set value
for trigger level setting
[MODE]
or  [MODE]
or  [MODE]
or 
7. Delay timer