KEYENCE IB Series - Manual (Page 118)

A-10 IB-E
A
ppendix
3
Factory Setting (Default Value) List
This section describes the factory settings (default values).
If the initial reset is performed, the default values will be restored as below except for the
calibration function.
"3-5 Initial Reset (Initialize)" (page 3-12)
Values set on the main screen
The same values are set in banks 0 to 3.
Basic and advanced setting
Setting item Default value
HIGH setting value 20.00
LOW setting value 10.00
Shift target value 0..00
Setting item Default value Description
1. Measurement mode
Pct
Percentage mode
2. Received/Blocked light mode
LiGhT
Received light mode
3. Averaging/High-pass filter
64
Average number of times: 64
4. Output mode
no
Normally open
5. Hold function
S-H
Sample hold
6. Timing input
LEvEL
Level
7. Delay timer
oFF
Delay timer disabled
8. Hysteresis
0.00
0.00
9. Analog output scaling
dEFLt
No scaling
10. External input
dEFLt
External input function not
changed from default settings
11. Bank switching method
btn
Button switching
12. Save zero-shift state
M-oFF
Not saved in non-volatile memory
(EEPROM)
13. Save adjust state
M-oFF
Not saved in non-volatile memory
(EEPROM)
14. Adjust level
20P
Adjust level 20P
15. Auto adjust function
oFF
Auto adjust function disabled
16. Check output function
oFF
Check output function disabled
17. Error output mode
dEFLt
Normal mode
18. Display digit
dEFLt
Default setting
19. Power save function
oFF
OFF
20. Judgment indicator color
dEFLt
HI: Red, GO: green, LO: red
21. P.V. value display color
dEFLt
HI, LO, Error: red
GO: Green
Setting item Default value Description
Calibration function
dEFLt
No correction